🔥❄️ Furnace Keeps Clicking But Won’t Start? Don’t Keep Resetting It ❄️🔥

🔥❄️ Furnace Keeps Clicking But Won’t Start? Don’t Keep Resetting It ❄️🔥

If your furnace keeps clicking or repeatedly tries to start but never fully turns on, it’s usually an ignition/safety problem. Most furnaces will attempt to ignite a few times, and when they don’t “prove” flame correctly, they shut down to protect your home and the equipment. That’s why clicking often turns into no heat.

At Uptown Heating & Air Conditioning, we find the real cause fast and restore safe, steady heat.

⚠️ Common Signs
✔️ Clicking sounds and repeated start attempts
✔️ Blower may run, but burners never stay on
✔️ Heat comes on for a few seconds, then shuts off
✔️ Furnace locks out and stops trying until reset

⚠️ Most Common Causes
✔️ Weak ignitor / ignition failure
✔️ Dirty flame sensor (burners light then shut down)
✔️ Gas supply or gas valve issues
✔️ Dirty burners / clogged orifices
✔️ Pressure switch or venting problem
✔️ Control board or wiring issue

🚫 Avoid This: Constantly turning it off/on or resetting it. Repeated failed ignition cycles can cause lockouts, more wear, and bigger repairs.

🛠️ Why Homeowners Choose Uptown
⭐ Licensed HVAC professionals
⭐ Full ignition + safety diagnostics
⭐ Honest, clear recommendations
⭐ Service for all major furnace brands

📅 Schedule your furnace check today!
📍 Houston, Katy, Cypress, Spring, Tomball & surrounding areas

🔖 Hashtags
#UptownAC #FurnaceRepair #NoHeat #HoustonHVAC #HeatingService
#HomeComfort #WinterReady #HVACTech #UptownHeatingAndAir